https://www.facebook.com/photo.php?f...r¬if_t=like
Been busy over Easter here. Built ala Simon McB's style low drag down force producing Splitter. I've extended the original Splitter to a total of 180mm out front and 400mm back to level with the front wheel arches. Fences are made from Plastic which we use in Speedway cars here whilst the base is 12mm Plywood with a joint about 450mm from the left side so that if I have a damage moment it only has to a half that needs replacing (well that's the plan). Ground clearance is 110mm. Thoughts???? Should I make a a Mount for the middle at the back of the Splitter? At the moment it's just bolted to the original Factory Splitter which has had stiffening mods mainly in the centre.