|
| Site Partners: | SpotterGuides | Veloce Books |
| Related Sites: | Your Link Here |
|
|
|||||||||
|
||||||||||
|
|
|||||||||
|
||||||||||
|
|
16 Oct 2006, 14:35 (Ref:1739395)
|
#1 | ||
 Race OfficialVeteran
Join Date: May 2003
Posts: 11,142
  |
Lobro Joints
A racer from one of the series I race in posted the following on our race series forum, I wondered if anyone here could help:
Can anyone shed some light on this one?! I run GKN lobro joints inboard and outboard on my Davrian. Inboard are No10 - as used on formula fords. I can get hold of these, not problem. On the outboard, for some reason a smaller joint has been fitted. Again lobro, but there are no identfication marks on it. The outer diameter apprears to have been machined. again the joint has 6 balls, dia approx 14.3mm, the shaft going into the joint has a 19 spline and the cage OD is 51.90mm. Any clues? Cheers |
||
|
|
|
17 Oct 2006, 10:15 (Ref:1740004)
|
#2 | |
|
Veteran
Join Date: Jul 2005
Posts: 1,981
|
Have you spoken to Tim Duffy?
I had a MkVIII and the outer lobros were to suit the Allegro (yes, BL!) stub axles which were an upgrade from the weaker Chrysler Imp versions. |
|
|
|
|
|
23 Oct 2006, 11:35 (Ref:1746067)
|
#3 | ||
|
Veteran
Join Date: Jul 2002
Posts: 6,704
|
which version are used on mk2 golfs?
|
||
|
|
__________________
Chase the horizon
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| F1 Suspension Flexure Joints | sideburnsdave | Racing Technology | 10 | 10 Apr 2006 16:31 |
Linear Mode
